Suzuki Grand Vitara Boot Trim Clip
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Suzuki Grand Vitara these days. With your sample on the bench this is a realistic reproduction job.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $4 – $10
- Estimated print time: 15–30 minutes
- Minimum order: 6
- Final pricing is confirmed by quote.
This is the kind of boot trim clip that dealers only sell as part of a whole assembly — if they can supply it at all for a Suzuki Grand Vitara these days. With your sample on the bench this is a realistic reproduction job.
Why these break
Boot and tailgate trim clips crack with age. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
The process is simple: drop the part in or send clear photos with a ruler in frame, we confirm fit details, and print replacements — often with a little extra material where the original always cracked.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Suzuki |
|---|---|
| Model | Grand Vitara |
| Year range | 1998–2018 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Boot and tailgate trim clips crack with age |
| Typical use case | Direct replacement for the original boot trim clip on the Suzuki Grand Vitara. |
Printing & reverse engineering
| Can print directly | No |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 15–30 minutes |
| Estimated cost range | $4 – $10 |
| Expected lifespan | 3–5 years of Australian UV |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
