Sea Jay Hatch Latch
Spares support for older Sea Jay products is patchy at best. Reproducing the hatch latch locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Spares support for older Sea Jay products is patchy at best. Reproducing the hatch latch locally is often quicker and cheaper than the hunt for old stock. We've made this style of part before and can usually print yours without drama.
Why these break
Hatch latches go brittle in salt and sun. Heat cycling is the killer here: years of expanding and contracting work-hardens the plastic until a routine bump becomes the final straw.
How we reproduce them
We model these in CAD from your sample, print a test-fit first, then run the final part once the fit is confirmed. Expect a few days end to end.
We print these in ASA. ASA is the UV-stable cousin of ABS — it holds its colour and strength through years of Australian sun where the original plastic went chalky and brittle.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Sea Jay |
|---|---|
| Vehicle / equipment type | Boat / outboard |
| Common failure mode | Hatch latches go brittle in salt and sun |
| Typical use case | Direct replacement for the original hatch latch on the Sea Jay. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ASA |
| Alternative materials | Nylon |
| Print technology | FDM |
| Difficulty | Medium |
| Estimated print time | 1–2 hours |
| Estimated cost range | $14 – $32 |
| Expected lifespan | 4–6 years outdoors |
| Outdoor suitable | Yes |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
