Toyota LandCruiser 79 Series Boot Latch Cover
The Toyota LandCruiser 79 Series is a vehicle worth keeping right, and a broken boot latch cover shouldn't be the thing that lets it down. We've made this style of part before and can usually print yours without drama.
Broken part? We may be able to recreate it — ask us about this part.
- Estimated cost: $10 – $24
- Estimated print time: 1–2 hours
- Final pricing is confirmed by quote.
The Toyota LandCruiser 79 Series is a vehicle worth keeping right, and a broken boot latch cover shouldn't be the thing that lets it down. We've made this style of part before and can usually print yours without drama.
Why these break
Latch trim cover cracks around its clips. The factory part is made from styrene-based plastic that loses its plasticisers over the years. It gets glassy, then one warm day it lets go under a load it used to handle easily.
How we reproduce them
This is a quick job on our end — we take dimensions from your old part, adjust for print tolerances, and run a small batch so you have spares for next time.
We print these in ABS. ABS matches the look and feel of the factory plastic, takes a sanded or textured finish well, and handles cabin temperatures without complaint.
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples. Bring in the damaged part or upload photos for assessment and we'll give you a straight answer before any work starts.
Part details
| Manufacturer | Toyota |
|---|---|
| Model | LandCruiser 79 Series |
| Year range | 1999–2023 |
| Vehicle / equipment type | Passenger vehicle / ute |
| Common failure mode | Latch trim cover cracks around its clips |
| Typical use case | Direct replacement for the original boot latch cover on the Toyota LandCruiser 79 Series. |
Printing & reverse engineering
| Can print directly | Yes |
|---|---|
| Can scan from broken sample | Yes |
| Can redesign / improve | Yes |
| Recommended material | ABS |
| Alternative materials | PETG |
| Print technology | FDM |
| Difficulty | Easy |
| Estimated print time | 1–2 hours |
| Estimated cost range | $10 – $24 |
| Expected lifespan | 4–6 years in cabin conditions |
| Outdoor suitable | No |
| Heat resistant | No |
| Load bearing | Depends |
| Requires post-processing | No |
Ask us about this part
Many plastic parts can be recreated, repaired, redesigned, or printed, depending on size, load, heat, material, and available samples.
